These are our 950HP 3.5″ Heavy Duty Carbon Fiber drive shafts for the Eclipse and Talon. This shaft is designed to replace the first 2 shafts of the factory 3-piece system and for use with the larger 25-spline 300M upgraded transfer case output shafts. It also includes a custom 7075-T6 aluminum plate to convert the CV back to a u-joint style end and bolt to the factory rear shaft section. 40% lighter than the stock front two pieces! The first 2 pieces of the stock shaft is 22lbs and our single is only 12lbs. The front angle was 2 degrees and the back was 7 degrees (not good), the problem is the rear joint would move more than 2 times as much as the front and cause a very nasty vibration. The AE-7 manual of Automotive engineers doesn’t recommend any driveshaft to have more than a 1 degree difference from one operating angle to the other (this would be a 5 degree spread). This shaft is rated for 950HP and comes complete with a conversion plate for the CV end and all hardware to make this a job that can be done in the garage. Disassembly of the stock drive shaft required to attach to the rear drive shaft to the new section.
Part Number: MISH1-HD25-C – SPECIAL ORDER; DROP SHIP FROM MANUFACTURER